Installing The 5881/5882 Receiver - ADEMCO Vista-10SE Installation And Setup Manual

VISTA-10SE Installation and Setup Guide

Installing the 5881/5882 Receiver

RF System Installation Advisories
Follow the guidelines below when installing the RF receiver. (Disregard if the receiver is
mounted in the control cabinet.)
• Place the RF receiver in a high, centrally located area for best reception.
• Do not locate the receiver or transmitters on or near metal objects. This decreases range
and/or block transmissions.
• Do not locate the receiver in an area of high RF interference (revealed by frequent or
prolonged lighting of the LED in the receiver; random flicker is OK).
• The RF receiver must be at least 10 feet from any remote keypads to avoid interference
from the microprocessors in those units.
Installation and Setup of the 5881/5882 Receiver
To install the receiver, take the following steps (refer to Figure 8 below):
ON OFF
5 1. Set the receiver's DIP switch for device address 0, as described in its instructions (all
4
< <
switches shown at left are in the OFF position).
3
2
2. Mount the receiver. The RF receiver can detect signals from transmitters within a
1
nominal range of 200 feet. Take this into consideration when determining mounting
location.
3. Connect the receiver's wire harness to the control's keypad terminals (4, 5, 6, and 7). Plug
the connector at the other end of the harness into the receiver.
4. Refer to the installation instructions provided with the receiver for further installation
procedures regarding antenna mounting, etc.
CIRCUIT
BOARD
MOUNTING
HOLES
5-2
ANTENNAS
INSERT IN
RIGHT-HAND
TERMINALS
DIP SWITCH INTERFERENCE
INDICATOR LED
DIP SWITCH #5 (PRESET ONLY ON 5881EH)
ON: SETS 5881EH FOR USE IN COMMERCIAL
FIRE APPLICATIONS (SEE THE RECEIVER'S
INSTRUCTIONS)*.
OFF: USE IN NON-COMMERCIAL FIRE
INSTALLATIONS.
* FOR COMMERCIAL FIRE APPLICATIONS
THE 5881EH PC BOARD MUST BE MOUNTED
IN A SEPARATE CABINET (SEE RECEIVER'S
INSTRUCTIONS FOR DETAILS).
Figure 8. 5881/5882 RF Receiver (cover removed)
WWW.DIYALARMFORUM.COM
TO CONTROL'S REMOTE KEYPAD
CONNECTION POINTS. EACH RECEIVER
MUST BE ON INDIVIDUAL HOME RUN.
USE MAX. of 220 ft. [67m of #22 (0.64mm)
WIRE or 550 ft. (168m) of #18 (1mm) WIRE
FOR EACH RUN]. OBSERVE 20 ft. MAX.
FOR COMMERCIAL FIRE INSTALLATIONS.
(SEE RECEIVER'S INSTRUCTIONS.)
YELLOW
DIP SWITCH WHITE AREAS = SWITCH
RED
HANDLES. POSITIONS 2-4 DETERMINE
BLACK RECEIVER'S ADDRESS. CONSULT
CONTROL'S INSTRUCTIONS FOR
GREEN
ADDRESS TO USE. DIP SWITCH BELOW
SHOWN SET FOR ADDRESS "0."
WIRING
OPENING
PLUG & SOCKET
SWITCH RECEIVER ADDRESS SETTINGS
POSITION (" - " MEANS OFF)
0 1 2 3 4 5 6
5 PRESENT ONLY ON 5881EH (SEE TEXT AT LEFT)
ON ON ON ON
4
ON ON ON ON
3
ON ON ON ON
2
1
FOR FUTURE USE
7