Thermostat Wall Control Location; Tools And Supplies Needed; Inspect Appliance And Components - Quadra-Fire MTVERNON-AE-CSB Installation Manual

B. Thermostat Wall Control Location
The thermostat wall control's location will have some affect
on the appliance's operation.
• Maximum wire length from appliance is 100 feet (30.48m)
continuous unspliced wire. Recommended 20 gauge wire,
solid copper .
• When located close to the appliance, it may require a
slightly higher temperature setting to keep the rest of the
house comfortable.
• When located in an adjacent room or on a different floor
level, you will notice higher temperatures near the appli-
ance.
CAUTION
The wall control is an integral part of the appliance. No other
wall control or thermostat can be substituted.
C. Tools And Supplies Needed
Tools and building supplies normally required
for installation, unless installing into an existing
masonry fireplace:
Reciprocating Saw
Hammer
Tape Measure
1/4" Self-Tapping Screws
REV
Hi-temp Caulking Material
Safety Glasses
Electric Drill & Bits (1/4")
May also need:
Vent Support Straps
May 2, 2014
Channel Locks
Phillips Screwdriver
Plumb Line
Framing Material
REVISIONS
Gloves
Framing Square
Level
Venting Paint
D. Inspect Appliance and Components
• Open the appliance and remove all the parts and articles
packed inside the Component Pack. Inspect all the parts
and glass for shipping damage.
• Report to your dealer any parts damaged in shipment.
• All labels have been removed from the glass door.
• Plated surfaces have been wiped clean with a soft cloth,
if applicable.
• Read all the instructions before starting the installation.
MULTI-FUEL IGNITER
Follow these instructions carefully during the
THIS IGNITER IS REQUIRED FOR
installation to ensure maximum safety and benefit.
BURNING FUELS OTHER THAN
• Follow pipe manufacturer instructions for installation WOOD PELLETS.
and air clearance requirements.
THIS IGNITER CAN ALSO BE USED AS A
BACKUP FOR WOOD PELLETS.
quired for burning multi-gran fuels and is includ-
ed in the component pack. Multi-fuels include,
corn, sunflower seeds, and wheat.
UNLESS OTHERWISE SPECIFIED DIMS ARE INCHES[MM] & : TOLERANCES ARE: (2) PLACE DEC : ± 0.03
OUTSIDE MATERIAL.
CONFIDENTIAL PROPERTY OF HEARTH & HOME TECHNOLOGIES INC.
DATE
ECO # BY
Risk of Fire
Damaged parts could impair safe operation.
Do NOT install damaged, incomplete or
substitute components.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided
by, the following actions:
• Installation & use of any damaged appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
• Operating appliance without fully assembling all
components.
• Operating appliance without legs attached (if supplied
with unit).
• Do NOT Overfire
Or any such action that may cause a fire hazard.
7034-277B
MT. VERNON AE
ITEM PART NUMBER
300 Watt Igniters come
installed in brand new Mt.
Vernon AE units and are
for pellet fuel only. The
380 Watt Igniter is re-
NORMAL DIM & INSIDE MATERIAL. OUTSIDE APEX INSIDE APEX - DIMS ENCLOSED BY AN OVAL ARE CRITICAL DIMENSIONS
PART NAME:
WARNING
DRAWN BY: SCALE:
THIS PRINT IS CHECKED AND CONTROLLED BY THE ENGINEERING
DEPARTMENTS OF HEARTH & HOME TECHNOLOGIES INC.
WARNING
PART NAME
(3) PLACE DEC: ± 0.005 ANGLE: ± 2° FRACTION: ± 1/16
MATERIAL:
PART NUMBER: REV
SHEET:
5