Table of Contents
Advertisement
SANTA FE FREESTANDING
B. Thermostat Wall Control Location
The thermostat wall control's location will have some affect
on the appliance's operation.
•
Maximum wire length from appliance is 100
feet (30.48m) with continuous non-spliced wire.
Recommended 20 gauge wire, solid copper .
•
When located close to the appliance, it may require a
slightly higher temperature setting to keep the rest of
the house comfortable.
•
When located in an adjacent room or on a different
floor level, you will notice higher temperatures near
the appliance.
C. Tools And Supplies Needed
Tools and building supplies normally required
for installation, unless installing into an existing
masonry fireplace:
-
Reciprocating Saw
-
Channel Locks
-
Hammer
-
Phillips Screwdriver
-
Tape Measure
-
Plumb Line
-
1/4" Self-Tapping Screws
-
Framing Material
-
Hi-temp Caulking Material
-
Gloves
-
Safety Glasses
-
Framing Square
-
Electric Drill & Bits (1/4")
-
Level
May also need:
-
Vent Support Straps
-
Venting Paint
6
Risk of Fire!
•
Damaged parts could impair
safe operation.
•
Do NOT install damaged, incomplete or
substitute components.
Hearth & Home Technologies disclaims
any responsibility for, and the warranty will
be voided by, the following actions:
•
Installation and use of any damaged appliance.
•
Modification of the appliance.
•
Installation other than as instructed by Hearth &
Home Technologies.
•
Installation and/or use of any component part not
approved by Hearth & Home Technologies.
•
Operating appliance without fully assembling
all components.
•
Operating appliance without legs attached (if supplied
with appliance).
•
Do NOT Over fire
Or any such action that may cause a fire hazard.
D. Inspect Appliance and Components
•
Open the appliance and remove all the parts and
articles packed inside the Component Pack. Inspect all
the parts and glass for shipping damage.
•
Report to your dealer any parts damaged in shipment.
•
All labels have been removed from the glass door.
•
Plated surfaces have been wiped clean with a soft
cloth, if applicable.
•
Read all the instructions before starting the installation.
Follow these instructions carefully during the
installation to ensure maximum safety and benefit.
•
Follow pipe manufacturer instructions for installation
and air clearance requirements.
7050-801E
WARNING
WARNING
09/20
Advertisement
Table of Contents
