Thermostat Wall Control Location; Tools And Supplies Needed; Inspect Appliance And Components - Quadra-Fire SANTAFE-MBK Installation Manual

SANTA FE FREESTANDING
B. Thermostat Wall Control Location
The thermostat wall control's location will have some affect
on the appliance's operation.
• Maximum wire length from appliance is 100 feet
(30.48m) continuous non-spliced wire. Recommended
20 gauge wire, solid copper
• When located close to the appliance, it may require a
slightly higher temperature setting to keep the rest of
the house comfortable.
• When located in an adjacent room or on a different
floor level, you will notice higher temperatures near the
appliance.
C. Tools And Supplies Needed
Tools and building supplies normally required
for installation, unless installing into an existing
masonry fireplace:
Reciprocating Saw
Channel Locks
Hammer
Phillips Screwdriver
Tape Measure
Plumb Line
1/4" Self-Tapping Screws
May also need:
Vent Support Straps
D. Inspect Appliance and Components
• Open the appliance and remove all the parts and
articles packed inside the Component Pack. Inspect all
the parts and glass for shipping damage.
• Report to your dealer any parts damaged in shipment.
• All labels have been removed from the glass door.
• Plated surfaces have been wiped clean with a soft
cloth, if applicable.
• Read all the instructions before starting the
installation. Follow these instructions carefully
during the installation to ensure maximum safety
and benefit.
• Follow pipe manufacturer instructions for
installation and air clearance requirements.
6
.
Framing Material
Hi-temp Caulking Material
Gloves
Safety Glasses
Framing Square
Electric Drill & Bits (1/4")
Level
Venting Paint
Risk of Fire!
• Damaged parts could impair safe operation.
• Do NOT install damaged, incomplete or
substitute components.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided
by, the following actions:
• Installation and use of any damaged
• Modification of the appliance.
• Installation other than as instructed by Hearth &
Home Technologies.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
• Operating appliance without fully assembling all
components.
• Operating appliance without legs attached (if supplied
with appliance).
• Do NOT Over fire
Or any such action that may cause a fire hazard.
7050-145L
WARNING
WARNING
appliance.
August 3, 2018