I Programming Channel Names (Regular Memory Channel Only); I Programming Group Names (Group Memory Channel Only) - Icom iC-A210E Instruction Manual

I Programming channel names
(Regular memory channel only)
The regular memory channel can display a 6-character name
in addition to the memory number.
q Push [RCL], then rotate [O-DIAL] to select the regular
memory channel in the memory mode.
w Rotate [DIAL] to select the desired channel.
e Push [MEM], then rotate [O-DIAL] to select "CH NAME."
r Push [MEM], then memory channel name's 1st digit
blinks.
t Rotate [DIAL] to select the desired character.
• The character type as shown below is selectable.
• Push [DIAL] to switch capital (A, B, C, ···) → lower case (A, B, C,
···) → number (0, 1, 2, ···) → capital (A, B, C, ···) in order.
y Rotate [O-DIAL] to select the next input digit.
u Repeat t–y to input the memory channel name.
i Push [MEM] to decide the memory channel name.
• Selectable characters
0 1 2 3 4 5 6 7 8 9 : ; < = > ? @
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z [ \ ]
^ _ `
a b c d e f g h i j k l m n o p q r s t u v w x y z { | } ~ I ! " # $
∗
% & ' ( ) + , – . /
MEMORY OPERATION
I Programming group names
(Group memory channel only)
The group memory channel can display a 6-character name
in addition to the group number ("GRP01"–"GRP20").
q Push [RCL], then rotate [O-DIAL] to select the desired
memory channel in the memory mode.
• Rotate [O-DIAL] to select the memory channel type if necessary.
w Push [DIAL], and then rotate [O-DIAL] to select the mem-
ory group from GRP01 to GRP20, if necessary.
• Push [DIAL] again to decide the memory group.
e Push [MEM], then rotate [O-DIAL] to select "GRP NAME".
r Push [MEM], then group name's 1st digit blinks.
t Rotate [DIAL] to select the desired character.
• The character type as shown left "Selectable characters" is se-
lectable.
• Push [DIAL] to switch capital (A, B, C, ···) → lower case (A, B, C,
···) → number (0, 1, 2, ···) → capital (A, B, C, ···) in order.
y Rotate [O-DIAL] to select the next input digit.
u Repeat t–y to input the group name.
i Push [MEM] to decide the group name.
3
03
15