Programming Channel Names (Regular Memory Channel Only); Programming Group Names (Group Memory Channel Only) - Icom IC-A210 Instruction Manual

■ Programming channel names
(Regular memory channel only)
The regular memory channel can display a 6-character
name in addition to the memory number.
q Push [RCL] to enter the memory mode, then rotate [O-
DIAL] to select a desired regular memory channel in the
memory mode.
w Rotate [DIAL] to select a desired channel.
e Push [MEM], then rotate [O-DIAL] to select "CH NAME."
r Push [MEM]. The memory channel name's 1st digit blinks.
t Rotate [DIAL] to select a desired character.
• The character type as shown below is selectable.
• Push [DIAL] to switch from capital letters (A, B, C, ···) → lower
case (a, b, c, ···) → number (0, 1, 2, ···) → then again to capital
letters (A, B, C, ···) in sequential order.
y Rotate [O-DIAL] to select the next input digit.
u Repeat t–y to input the memory channel name.
i Push [MEM] to set the memory channel name.
• Selectable characters
0 1 2 3 4 5 6 7 8 9 : ; < = > ? @
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z [ \ ]
^ _ `
a b c d e f g h i j k l m n o p q r s t u v w x y z { | } ~ ■ ! " #
∗
$ % & ' ( ) + , – . /
MEMORY OPERATION
■ Programming group names
(Group memory channel only)
The memory groups can display a 6-character name in addi-
tion to the group number ("GRP01"–"GRP20").
q Push [RCL], then rotate [O-DIAL] to select a desired
memory channel in the memory mode.
• Rotate [O-DIAL] to select the memory channel type if neces-
sary.
w Push [DIAL], and then rotate [O-DIAL] to select the
memory group from GRP01 to GRP20, if necessary.
• Push [DIAL] again to set the memory group.
e Push [MEM], then rotate [O-DIAL] to select "GRP
NAME".
r Push [MEM], and the group name's 1st digit blinks.
t Rotate [DIAL] to select a desired character.
• The character type as shown left "Selectable characters" is se-
lectable.
• Push [DIAL] to switch from capital letters (A, B, C, ···) → lower
case (a, b, c, ···) → number (0, 1, 2, ···) → then again to capital
letters (A, B, C, ···) in sequential order.
y Rotate [O-DIAL] to select the next input digit.
u Repeat t–y to input the group name.
i Push [MEM] to set the group name.
3
03
15