Table of Contents
Advertisement
6
Remove camshaft timing gear, remove
timing chain and place in the timing case,
tightening torque 80 Nm.
7
Remove and install Woodruff key (6) and
spacer washer (7).
Installation note
Note color markings on camshaft timing
gear and timing chain.
Assemble camshaft timing gear so that on the
single roller chain the wide collar points to the
camshaft and on the dual roller chain the
curvature points to the camshaft.
8
In order to loosen or tighten up camshaft
timing gear hold in position with flats at the rear
of camshaft with a fork wrench (24 mm).
9
Remove and install rocker arm bearing
supports (61) (05-235), tightening torque
20 Nm.
10 Remove camshaft. Before installing
lubricate all bearing points with engine oil.
Check, whether the marking on set collar aligns
with edge on the cylinder head.
Installation note
If camshaft is to be replaced, all rocker arms and
rocker shafts have to be replaced as a set.
05.0906 - 220/10
4
8
9
EXIT
Hide quick links:
Advertisement
Table of Contents
