Table of Contents
Advertisement
Corrections
5
Remove rocker arm bearing support
(05235).
6
Press hydraulic valve clearance compens-
ating element (58), together with the washer
aluminum or brass mandrel, and finally slide into
the rocker arm up to the snap ring stop (56)
again. Use a thinner washer (residual stroke too
small) or a thicker washer (residual stroke too
large).
If specified residual stroke cannot be achieved
with the washers available (57), depending on
residual stroke measured, use a thinner or
thicker ball socket (55) (see note, on the washer
and ball socket tables).
Caution!
Before carrying out the installation fill reservoir
chamber of the hydraulic valve clearance com-
pensating element with engine oil (05- 211,
Number 3).
The grooves in the washer (57) must point in the
direction of the compensating element setbolt.
7
Install rocker arm bearing support (05-235).
8
Repeat tests, Numbers 1 to 3.
Note
Before carrying out the test turn the crankshaft a
few times by using the starter.
9
The installation is carried out in the reverse
sequence of the removal.
10 Check for leaks when engine is running.
05.0906 - 214/8
EXIT
Hide quick links:
Advertisement
Table of Contents
