Configuring IPv6 Routing Features (CLI)
This section provides information about the commands you use to configure
IPv6 routing on the switch. For more information about the commands, see
Dell Networking N2000, N3000, and N4000 Series Switches CLI
the
Reference Guide
Configuring Global IP Routing Settings
Beginning in Privileged EXEC mode, use the following commands to
configure various global IP routing settings for the switch.
Command
configure
sdm prefer dual-ipv4-
and-ipv6 default
ipv6 unicast-routing
ipv6 hop-limit
ipv6 icmp error-interval
burst-interval
[
size
]
exit
1256
Configuring IPv6 Routing
at support.dell.com/manuals.
Purpose
Enter global configuration mode.
Select a Switch Database Management (SDM) template
to enable support for both IPv4 and IPv6. Changing the
SDM template requires a system reload.
Globally enable IPv6 routing on the switch.
limit
Set the TTL value for the router. The valid range is 0 to
255.
Limit the rate at which IPv4 ICMP error messages are sent.
burst-
burst-interval
•
initialized (Range: 0–2147483647 milliseconds).
burst-size
•
can be sent during a burst interval (Range: 1–200).
Exit to Privileged EXEC mode.
— How often the token bucket is
— The maximum number of messages that