Configuring Rip Features (Cli); Configuring Global Rip Settings - Dell Networking N4000 Series Configuration Manual

Configuring RIP Features (CLI)

This section provides information about the commands you use to configure
RIP settings on the switch. For more information about the commands, see
Dell Networking N2000, N3000, and N4000 Series Switches CLI
the
Reference Guide

Configuring Global RIP Settings

Beginning in Privileged EXEC mode, use the following commands to
configure various global RIP settings for the switch.
NOTE:
RIP is enabled by default. The Global RIP Settings are optional.
Command
configure
router rip
split-horizon {none |
simple | poison}
auto-summary
no hostroutesaccept
default-information
originate
metric-
default-metric
value
enable
CTRL + Z
show ip rip
at support.dell.com/manuals.
Purpose
Enter global configuration mode.
Enter OSPF configuration mode.
Set the RIP split horizon mode.
• none — RIP does not use split horizon to avoid routing
loops.
• simple — RIP uses split horizon to avoid routing loops.
• poison — RIP uses split horizon with poison reverse
(increases routing packet update size).
Enable the RIP auto-summarization mode.
Prevent the switch from accepting host routes.
Control the advertisement of default routes.
Set a default for the metric of distributed routes.
metric-value
The
of the default route. (Range: 1–15)
Reset the default administrative mode of RIP in the router
(active)
Exit to Privileged EXEC mode.
View various RIP settings for the switch.
variable is the metric (or preference) value
Configuring RIP
1209