Kenmore Washer/Dryer Owner's Manual And Installation Instructions page 30

STEP 2. Attach the hose with the red
coupling to the hot water (bottom) inlet
valve. Attaching the red coupling first
makes it easier to tighten connection
with pliers. Screw on coupling by hand.
Make an additional two-thirds turn with
pliers to tighten coupling. DO NOT
OVERTIGHTEN; this could damage
the valves.
STEP 3. Attach the hose with the blue
coupling to the cold water (top) inlet
valve. Screw on coupling by hand. Make
an additional two-thirds turn with pliers
to tighten coupling. DO NOT OVER-
TIGHTEN; this could damage valves.
F. CONNECT INLET HOSES
TO WATER FAUCETS
:STEP 1. Make sure washer basket is
err,pty. Run water through both faucets
into a bucket or laundry/tub to get rid of
3a'ticles in the water lines that might
,slog hoses. Determine which faucet is
qot and which is celd. Mark the hot water
faLcet.
STIEP 2. Attach the, hose with the red
coupling to the hot water faucet. Screw
on coupling by hand. Make an additional
twc-thirds turn with pliers to tighten coupling.
DO NOT OVERTIGHTE!N; this could
darnage the coupling.
STIEP 3. Attach the hose with the
blu£ coupling to the cold water faucet.
Screw on coupling to faucet by hand.
Make an additional two.-thirds turn with
pliers to tighten coupling. DO NOT
OVERTIGHTEN; this could damage
the coupling.
STEP 4. Turn on water faucets and
check for leaks. A small amount of
wafer will enter the washer. You will
drain this later.
If you have: You will need to buy:
Water faucets beyond the 2 longer water fill tqoses: 6 ft. hoses,
reach of water fill hoses Pa't No. 76314 or 10 ft hoses,
Pa't No. 350008
Parts listed are available from your local Sears store or Sears Service Center.
Call 1-800-366-PART (1-800-366-7278).
3O