Kenmore Washer/Dryer Owner's Manual And Installation Instructions page 28

D. CONNECT DRAIN HOSE
!
Proper connection of the drain hose
will protect your floors from damage
due to water leakage.
STEP 1. To prevent the drain hose from
coming off or leaking, it must be installed
per the following instructions:
IMPORTANT: To ensure proper installa-
tion, this procedure must be followed
exactly.
a. 'Wet the inside of the straight end of
the drain hose with tap water. DO
NOT USE ANY OTHER LUBRICANT.
b. ',Squeeze ears of silver,, double-wire
clamp with pliers to open. Place clamp
,aver the straight end of the drain hose
V4-inch from the end.
c. Open clamp. Twist hose back and forth
while pushing onto drain connector on
the side of the laundry center. Continue
until hose contacts the ribbed stops on
the cabinet.
AND
PUSH
d. Place clamp over area marked
"CLAMP:'.' Release clamp.
Soft
coupler
DrainZ
hose
_
Ribbed
stops
If you have: You will need to buy:
Drain hose that is too short Drain hose, Part No. 388423 and
hose kit, Part No. 285442
Drain hose that is too long Hose kit, Part No. 285442
A problem with lint clogging your drain Drain protector, Part No. 367031
Parts listed are available from your local Sears store or Sears Service Center.
Call 1-800-366-PART (1-800-366-7278).
28