Electrical Requirements; Electrical Connection Options - Kenmore Washer/Dryer Owner's Manual And Installation Instructions

Kenmore washer/dryer user manual
Hide thumbs Also See for Washer/Dryer:
Table of Contents

Advertisement

B. MAKE ELECTRICAL
CONNECTION
It is your responsibility:
• To contact
a qualified electrical
installer.
• To assure that the electrical
installation
is adequate
and in conformance
with
the National
Electrical
Code, ANSI/
NFPA 70-latest
edition and all local
codes and ordinances.
Copies of the code standards
listed
above may be obtained
from:
National
Fire Protection
Association
Batterymarch
Park
Quincy, Mlassachusetts
02269
ELECTRICAL
REQUIREMENTS
i-teJii_toJqi_i :I=.]i[_]l"
The proper electrical
connection
ensures
a safe installation
that
meets local code requirements.
A three-wire or four-wire, single
phase 120/240-volt,
60-Hz.,
AC-only,
electrical supply (or three-wire
or
four-wire, 120/208-volt if specified
on
serial/rating
plate) is required
on a.
separate
30-ampere
circuit, fused on
both sides of the line. A time-delay fuse
or circuit breaker is recommended.
This laundry center is manufactured
with
the 3-wire, frame-grounding
conductor
connected
to the NEUTRAL
(center) of
the wiring harness of the terminal block.
Do not have a fuse in the neutral or
grounding
circuit. A fuse in the neutral
or grounding
circuit could result in an
electrical
shock.
Use a 4-conductor
cord when the laundry
center is installed in a mobile
home or
an area where local codes do not permit
grounding
through the neutral.
ELECTRICAL
CONNECTION
OPTIONS
If Your Home Has:
3-wire electrical
receptacle
(NEMA Type 10-30R)
And You Will Be
GoTo
Connecting
To:
Page
A U.L.-listed, 120/240-volt
minimum, 30-amp., dryer
power supply cord.*
17-1.
3-wire direct
A fused disconnect or
19 - I1.
circuit breaker box.*
_.,,_- 3vt_
A U.L-listed,
120/240-volt
minimum, 30-amp., dryer
power supply cord.
4-wire eleclrical
receptacle
(NEMA Type 14-30R)
22 - II1.
J
A fused disconnect or
25 - IV.
4-wire direct
_
circuit breaker box.
5"
1
*If local codes do not permit the connection of a frame-grounding
conductor
to the neutral wire, see the instructions on page 21.
16

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents