Installing Satellite-Fi Ll Icemakers - Follett Symphony 25CT400A Installation, Operation And Service Manual

Installing Satellite-fi ll icemakers

Models 25CR400A/W, 50CR400A/W, 25HR400A/W, 50HR400A/W
See Icemaker Installation Manual (form #208600) for critical installation instructions for Satellite-
!
fi ll icemakers. Failure to comply with these instructions will result in poor performance and void
warranty.
1. Install Satellite-fi ll icemaker following instructions in icemaker manual.
2. Run uninsulated ice transport tube from dispenser through ice transport tube knock-out (Fig. 5G) or through counter
opening to icemaker.
3. Heat end of transport tube in cup of 160 F (71 C) hot water to soften and spread with pliers
before making connection to ease assembly and prevent coupler edge from cutting inner
wall of tube.
4. Insulate ice transport tube by sliding insulation over tube.
5. Adjust insulation to cover all exposed ice transport tubing including tubing inside dispenser
cabinet.
6. Check that insulated ice transport tube runs continuously uphill (with no dips) from icemaker
to dispenser.
7. Run bin signal wire from dispenser through utility knockout (Fig. 5F) or counter cut-out to icemaker and connect bin
signal wire (two-conductor twist lock) to bin signal plug on icemaker.
8. Plug dispenser power cord into 20 amp rated NEMA 5-20 wall socket.
9. Turn on dispenser water supply and check for leaks. Replace splash panel.
10. If dispenser is equipped with SensorSAFE remove protective plastic coating from dispenser lenses.
11. Remove top front cover by removing two screws at bottom corners of cover. Lift cover slightly and pull forward. Turn
on power and bin signal rocker switches. Replace front cover and secure with screws. Test operation.
12. Clean and sanitize icemaker following instructions in icemaker manual. Discard ice made during sanitizing process.
13. Clean and sanitize dispenser hopper following instructions on page 16. Installation is complete.
Fig. 9 – Ice transport tube and ice level control stat mounting for freestanding dispensers and countertop units
with Satellite-fi ll icemaker
ice level control stat
ice hose mounting bracket
.187 (5mm) ice tube hole
engaging pin
1"
ice tube
(25mm)
13
Hot Water
160 F (71 C)
3