Installing Satellite-Fill Icemakers; Installing Top Mount Icemakers - Follett 110CR400A/W Installation, Operation & Service Manual

Installing Satellite-fill icemakers

Models110CR400A/W
See Icemaker Installation Manual (form #208600) for critical installation instructions for remote
icemakers. Failure to comply with these instructions will result in poor performance and void
!
warranty.
1. Install Satellite-fill icemaker following instructions in icemaker manual.
2. Run uninsulated ice transport tube from dispenser through ice transport tube knock-out, (Fig. 5G) or through counter
opening to icemaker.
3. Insulate ice transport tube by sliding insulation over tube.
4. Adjust insulation to cover all exposed ice transport tubing including tubing inside dispenser cabinet.
5. Check that insulated ice transport tube runs continuously uphill (with no dips) from icemaker to dispenser.
6. Run bin signal wire from dispenser through utility knockout, (Fig. 5F) or counter cutout to the icemaker and connect
bin signal wire (two-conductor twist lock) to bin signal plug on icemaker.
7. Plug dispenser power cord into 20 amp rated NEMA 5-20 wall socket.
8. Turn on dispenser water supply and check for leaks. Replace splash panel.
9. Remove top front cover by removing two screws at bottom corners of cover. Lift cover slightly and pull forward. Turn on
power and bin signal rocker switches. Replace front cover and secure with screws. Test operation.
10. Clean and sanitize icemaker following instructions in icemaker manual. Discard sanitized ice.
11. Clean and sanitize dispenser hopper following instructions on page 14. Installation is complete.
Fig. 6 – Ice transport tube and ice level control stat mounting for freestanding dispensers and countertop units
with Satellite-fill icemaker

Installing top mount icemakers

Models 110CT400A/W
Dispensers with top mount icemakers cannot be mounted on legs. They must be bolted to counter.
!
Use gloves when lifting icemaker to protect hands from sheet metal edges.
1. Remove dispenser top front cover by removing two screws at bottom corners of cover, lifting cover slightly and pulling
forward.
ice level control stat
ice hose mounting bracket
3/16 (5mm) ice tube hole
engaging pin
1"
ice tube
(26mm)
12