Fitting Rear Fairing; Fitting Heel Protector - KTM 690 SMC 2008 Setup Instructions

WORK

Fitting rear fairing

3.9
Fitting the rear footrest bracket
3.10
Info
The operations are the same for the left and right sides.

Fitting heel protector

3.11
Info
The operations are the same for the left and right sides.
–
Remove screws
–
Open the filler cap. (
–
Take off the rear fairing.
–
Close the filler cap. (
100314-10
–
Position the license plate holder and cable harness.
–
Open the filler cap. (
–
Position the rear fairing and grab handles
tighten the screws of the grab handles.
–
Close the filler cap. (
–
Fit and tighten the screws on the rear fairing.
Guideline
Remaining screws, chassis
100315-10
–
Mount and tighten screws
–
Tighten the screws of the grab handles.
Guideline
Screw, handrail
–
Mount the seat. (
100314-10
–
Position the footrest bracket
Guideline
Screw, rear footrest bracket
100316-10
.

S. 8)
S. 8)
S. 8)

S. 8)
M6
.

M8
S. 6)
. Mount and tighten screws

M8x16
as shown in the figure. Fit and slightly
10 Nm (7.4 lbf ft)
20 Nm
(14.8 lbf ft)
.

25 Nm
(18.4 lbf ft)
9