Table of Contents
Advertisement
TROUBLESHOOTING REMOTE SYSTEM
SYMPTOM
1. Battery icon on LCD on transmitter.
2. LCD display is blank
3. LCD display shows "funny" display
4. Appliance does not come on.
5. Receiver cannot receive signal.
6. Blower is not on after the fireplace
is turned on
56D3049
POSSIBLE
ACTION
CAUSE
1. Low Battery
1. Replace batteries. Change batteries every 6 months.
2. Check battery installation or replace batteries.
3. Press Reset button at the back of the transmitter.
1. Wiring / Electrical
1. Slide the switch to ON, if appliance comes ON, wiring is not
Connections
2. If appliance does not come on,
2. Privacy (DIP)
1. Make sure the transmitter and receiver have the same DIP
switch setting on
transmitter does
not match receiver
3. Transmitter mea-
1. Move transmitter to a cooler place and wait until temperature
sures temperature
exceeding 99°F
and shows "HI" on
LCD
4. Distance between
1. Make sure the operating distance is less than 30 feet
the transmitter and
receiver is more
than 30 feet
1. Receiver is
1. Make sure the receiver is not located inside to tight of an
installed in an
enclosure
1. Blower setting is
1. Press FAN key to select Fan speed you desire.
off
2. Blower delay set-
2. Press and hold FAN key to set desired ON/OFF delays. This
ting is set too high
Changes or modifications to this unit
not expressly approved by the party
responsible for compliance could
void the user's authority to operate
the equipment.
the cause.
switch settings.
drops below 99°F.
enclosure.
is done in minutes.
TROUBLESHOOTING
69
Advertisement
Table of Contents
