Table of Contents
Advertisement
RESET BUTTON
1. The reset button can be used to reset the transmitter if transmitter is not working properly. The reset button is located
behind the battery door cover in the lower left corner of battery compartment. Using a paper clip, press the reset button
and the transmitter will reset and initialize for 10 seconds before it can be used.
TRANSMITTER
- See Figure 68
GENERAL
This remote control has two (2) operating modes — Manual and Thermostatic.
The control system can be set to temperature ranges between 45°F and 90°F. The blower
speed and flame height can be adjusted in either the manual and thermostatic mode.
The transmitter (See Figure 65) will operate the remote receiver from 1 ft. to a maxi-
mum of 30 feet. The distance is reduced when batteries are low or when the receiver
is inside a metal enclosure.
INITIAL START-UP RESET MODE - See Figure 69
1. After initial power up or when RESET button is pressed, the transmitter is reset.
The reset button is located behind the battery door of transmitter.
2. During system reset, all features of the LCD DISPLAY will be visible. After one
second, the LCD will be initialized. A typical reset display is shown in Figure 65.
Note that the temperature scale is degree F.
3. Press On button to select between °C and °F display. It will exit setting mode
automatically after 10 seconds if no key is pressed. The transmitter will send an
Off signal after reset.
4. After reset, the transmitter is operating in manual mode. See Figure 69.
MANUAL MODE - See Figure 70
1. Press the ON button once to turn on the appliance with max flame height.
2. Press the OFF button to decrease flame height.
• The first two pressing will decrease flame height to lower level.
• The third pressing will turn fireplace off.
3. If holding on OFF button for more than 3 second, fireplace will be shut off
THERMOSTATIC MODE - See Figure 71
1. Press the AUTO/FLAME button to enter the thermostatic mode.
2. In thermostatic mode, press the ON/▲ button or OFF/▲ button to set the desired set
temperature.
3. Once the setting is completed, the transmitter will automatically turn on the fireplace
when the room temperature is below the set temperature and turn off the appliance
when the room temperature is above the set temperature within 1 degree.
4. There will be a slight delay in the response of the unit (on/off) to a temperature.
Room temperature is monitored every 3 minutes.
5. Press the AUTO/FLAME button to exit the thermostatic mode. The transmitter
will be in the manual off mode and the fireplace will be shut off.
56D3049
OPERATING INSTRUCTIONS - REMOTE HI/LO WITH BLOWER
Auto/Flame Button
LCD Display
88
°
On
88
F
°
Button
set
ON
Fan
AUTO
FAN
FLAME
Button
OFF
AMBIENT
Figure 68 - Transmitter
70
Figure 69 - Reset Mode
70
Figure 70 - Manual Mode
70
75
°
set
Figure 71 -
Thermostatic Mode
F
Off
Button
° F
° F
F
°
F
Continued
47
Advertisement
Table of Contents
