Darning Stitch; Ostarting Tosew; For Darning Less Than 3/4" (2 Cm); To Adjust The Shape Of Darning Stitch - Kenmore 385.19365 Owner's Manual

Darning Stitch
Q Stitch pattern: 17
Q Thread tension dial: AUTO
® R: Automatic buttonhole foot
@ Darning shape: See below for setting
,, Starting to sew
[] Pull the button holder to the rear.
[] Place the ga_rment under the foot, Press the Up/Down
needle position button twice. Remove the fabric to the
left to draw both threads under the foot°
[] Lower the foot. Press down the foot control.
The machine wil! lock stitch, sew 16 rows of darning,
lock stitch again and the machine stops automatically.
* The size of one darn cycle is variable.
However, the maximum iength is 3/4" (2 cm) and the
maximum width is 9/32" (0_7 cm),
[] Turn the fabric and repeat sewing
_) Button holder
Hole
Starting point
@ 3/4" (2 cm)
O 9/32" (0.7 cm)
For darning less than 3/4" (2 cm)
Stitch to "Low" speed setting, 4 lock stitches will be
sewn first. Then sew to the desired length and press
the reverse button, The desired length has now been
determined. Continue sewing until the machine stops
automatically,
(_ Reverse button
Q Desired length
(_ Starting point
o To adjust the shape of Darning stitch
If one side of the darn is higher than the other, make
them even by pressing the stitch length "+" or "-" key.
When you press the "+" or "-'° key, d3 will be indicated
automatically_ You can adjust the shape of the darn by
pressing "+" or "-" key, dl to d5,
To memorize Darning stitch
When repeatedly sewing the same-size dam to repair a
side rip or belt loop, press "MEM" key and restart
sewing,
f
f'
8O
@ ® ® @
..................................... J
_[]@@
IAb_I_A_,A
UllllllllilII
IIIllllttlllllll
Iil!Yflll
J
®
l__i_
/
®
AAAAAAAA
IIIIIIJlJliJllll
IlllllJllHJJlll
UllllI!lEllIlII
IIIlllltiIlltU
VVVVVVV
lllllllllllIIIll
IiVViiiil
lllil_lllll
I_I llllilllllll
IiVVVIVV