Barracking; Memorizing Bartacking; Adjusting The Evenness Of Barracking - Kenmore 385.19365 Owner's Manual

Bartacking
O Stitch pattern: 18
(_ Thread tension dia!: AUTO
® F: Satin stitch foot
Switching to "Low" speed setting° 4 lock stitches will be
sewn first. Then sew to the desired length and press the
reverse button.,
The desired length has been now determined. Continue
sewing until the machines stops automatically.
* This stitch is used for reinforcement of the heavily
strengthened part of a garment.
The maximum bartack length is t" (2.5 cm) depending
upon fabric.
When you change the stitch length or stitch width, press
width "+", or "-" or length "+" or "-" key,
O Starting position
(_ Ending position
(_) Pre-set 5/8" (1.5 cm)
o Memorizing bartacking
When repeatedly sewing the same size bartack, press
"MEM" key and restart sewing.
(_) Length required
Q Reverse button
(_ Starting position
O Ending position
f
@ @ ®
t8 AUTO
i
J
1
XX®
Adjusting the evenness of bartacking
Make a test on an extra piece of fabric to check your
settings,, If the bartacking is uneven, adjust the stitch
length by turning the feed balancing dial as shown.
(_) Starting position
@ An extra length is left from the starting position
@ Turn the feed balancing dial to %" direction.
@ Matching the position. (Correct position)
@ An extra length is left from the returning position,
@ Turn the feed balancing dial to '-" position.
®
@
@
82