Adjusting The Stitch Width And Density In Buttonholes; To Change The Stitch Width; Oto Change The Stitch Density - Kenmore 385.19365 Owner's Manual

(Starting to sew continued)
[] Raise the buttonhole foot and draw the garment with
both needle and bobbin threads away about 4" (10cm)
and cut off°
Pull the bobbin thread so that the needle thread is
pulled out to the wrong side of fabric°
Knot both threads under the fabric.
Place a pin on the rear side of the bartack position so
that you do not need to worry about cutting the end of
buttonhole stitch.
Cut the opening with the buttonhole opener in your
accessory box.
0 Pin
_) Buttenholer opener t Seam ripper
(_ Punch (use for BH 3)
[] After sewing the buttonhole stitch, raise the buttonhole
lever until it stops.
(_ Buttonhole tever
Adjusting the Stitch Width and Density in
Buttonholes
[]
®
"° 1
To change the stitch width
The stitch width key controls the stitch width,
The pre-set buttonhole widths are: square buttonhole
5.0, rounded buttonhole 4.0, keyhote buttonhole 7.0.
Press "+" or "-" to adjust the stitch width of the entire
buttonhole, ranging between 2.5 to 7.0 depending on
the selected buttonhole.
O Narrower width by pressing "-"
(_ Wider width by pressing "+"
o To Change the Stitch Density
The stitch length key controls the stitch density.
The pre-set density varies from 0,4 to 0.7 according to
the buttonhole selected.
Press "+" or "--" to adjust the stitch density of the entire
buttonhole between 0.2 to 1.0 depending on the
selected buttonhole.
Press %" or "-" to adjust the stitch density between 0.5
to t,0 for the buttonhole density for U U "
® Denser stitch by pressing "-".
O Coarser stitch by pressing "+".
70