Driver Installations; Microsoft Windows ® Xp (Service Pack 2) - Icom id- rp4000v Instruction Manual

n Microsoft ® Windows

DRIVER INSTALLATIONS

® XP
(Service Pack 2)
Select
Click
The USB
(Universal Serial Bus)
is used for the connection between ID-
separately)
RP4000V and a PC.
So, the USB driver installation is required for the PC.
In addition, individual USB driver installation is re-
quired for each connector, because the communica-
tion port number difference.
In this instruction, describes with the installation of the
ID-RP4000V [SERVICE T] connector for example.
NOTE:
The ID-RP4000V connection may not be recog-
nized by the PC depending on the length of the
USB cable. Using as short a USB cable as possible
is recommended.
q Start up Windows.
• Quit all applications if activated.
w Insert the CD supplied with the ID-RP4000V, into
the CD drive.
e Connect the PC and ID-RP4000V [SERVICE T]
connector using with a USB cable
.
chase separately)
r "Found New Hardware ID-RP4000V SERVICE T"
appears as at left.
t The "Found New Hardware Wizard" will come up
as at left.
Select "No, not this time" then click [Next>].
6
4
cable
(A-B type; purchase
(A-B type; pur-
+ Continue to the next page.