Com Port Confirmation; D Microsoft Windows ® Xp/2000 - Icom id- rp4000v Instruction Manual

n COM port confirmation
D Microsoft ® Windows
Click
Click
Check the connected unit and connector names,
and COM port number.
(In this example, the USB serial port number is "3.")
® XP/2000
Click
After the driver installation, confirm the driver avail-
ability and the port number are recommended.
In this section, COM port number confirmation of the
ID-RP4000V [SERVICE T] connector is used for in-
struction example.
q Start up Windows.
w Connect the PC and the ID-RP4000V [SERVICE T]
connector through a USB cable
.
separately)
e Right click "My Computer" then select "Properties."
• "My Computer" is available in <Start> menu with Micro-
soft ® Windows ® XP.
r "System Properties" screen appears as at left.
Click [Hardware] tub and then click [Device Man-
ager].
t "Device Manager" screen appears.
Click " " of Ports (COM&LPT).
y Confirm "ICOM ID-RP4000V SERVICE T (COMQ)"
is displayed.
• If not displayed, or few COM port numbers are dis-
played at the same time, the driver installation may not
be installed properly. Un-install the USB driver then re-
install the driver again in such cases.
NOTE: "Q" is the COM port number, that is
used for the communication setting with the util-
ity software.
<e.g.: When driver re-installation is required>
"ICOM ID-RP4000V SERVICE T (COMQ) (COMQ)"
22 22
DRIVER INSTALLATIONS
(A-B type; purchase
4