Related Manuals for Icom IC-FR5300
Summary of Contents for Icom IC-FR5300
- Page 1 INSTRUCTION MANUAL VHF DIGITAL REPEATER iFR5300 UR-FR5300 UHF DIGITAL REPEATER iFR6300 UR-FR6300 IC-FR5300/IC-FR6300...
-
Page 2: Important
IMPORTANT Thank you for choosing this Icom product. This product is designed and built with Icom’ s state of the art technology and craftsmanship. With proper READ THIS INSTRUCTION MANUAL care, this product should provide you with years of CAREFULLY before attempting to operate the re- trouble-free operation. -
Page 3: Table Of Contents
Otherwise, a high n FCC information ..........10 input could damage the linear amplifier. CAUTION: DO NOT use non-Icom microphones. Other manufacturer’s microphones may have differ- ent pin assignments, and could damage the connector and/or the repeater. -
Page 4: Safety Training Information
Electromagnetic Interference/Compatibility from the properly installed antenna. This separa- tion distance will ensure that there is sufficient dis- During transmissions, your Icom radio generates RF tance from a properly installed externally-mounted energy that can possibly cause interference with other antenna to satisfy the RF exposure requirements devices or systems. -
Page 5: Informations En Matière De Sécurité
Interférence électromagnétique et compatibilité Cette distance de sécurité assurera que les per- sonnes soient placées suffisamment loin d’une En mode de transmission, votre radio Icom produit de antenne correctement fixée à l’extérieur pour sat- l’énergie de RF qui peut provoquer des interférences isfaire aux exigences en matière d’exposition aux... -
Page 6: Panel Description
PANEL DESCRIPTION n Front panel Function display q INTERNAL SPEAKER u MICROPHONE CONNECTOR [MIC] Outputs the received audio. This 8-pin modular jack accepts an optional micro- phone. w VOLUME CONTROL [VOLUME] (p. 7) KEEP the [MIC] connector cover attached to the Adjusts the audio output level. -
Page 7: D Function Display
PANEL DESCRIPTION D Function display I C O M I n c . q SIGNAL STRENGTH INDICATOR r GNSS INDICATOR Indicates the relative signal strength level. Displays when the UC-FR5300 is installed, and the GNSS (Global Navigation Satellite System) posi- w LOW POWER INDICATOR tioning is established. -
Page 8: D Accessory Connector
PANEL DESCRIPTION D Accessory connector Pin No. Pin Name Description Specification No connection — Input terminal for serial communication data. — Output terminal for serial communication data. — Input terminal for request-to-send data. — Output terminal for clear-to-send data. — No connection —... -
Page 9: Installation And Connections
INSTALLATION AND CONNECTIONS n Unpacking n Antenna connection After unpacking, immediately report any damage to For radio communications, the antenna is a critical the delivering carrier or dealer. Keep the shipping car- component, along with output power and sensitivity. tons. Select antenna(s), such as a well-matched 50 ø... -
Page 10: Front Panel Connection
Input port for PC programming CAUTION: DO NOT short pin 1 to ground as this can damage the internal 8 V regulator. DC voltage is applied to pin 1 for microphone operation. Only Icom micro- phones are recommended. n Rear panel connection... -
Page 11: Power Supply Connection
INSTALLATION AND CONNECTIONS n Power supply connection n Mounting the repeater D Using the supplied handles Make sure the repeater’s power is turned OFF when connecting a DC power cable. The supplied handles are used when mounting the re- peater into a 19 inch rack. The handles are installed on R WARNING! NEVER apply more than 16 V DC to the repeater’s front panel. -
Page 12: Operation
OPERATION n Receiving and transmitting D Base station operation D Repeater operation Receiving Ask your dealer for details of the repeater’s preset- q Push [POWER] to turn ON the power. tings. w Set the audio and squelch levels. ➥ Rotate [SELECT]* fully counterclockwise in ad- ➥ W hen the power is turned ON, the [PWR] indicator vance. -
Page 13: Maintenance
If you are unable to locate the cause of a problem The following chart is designed to help you correct or solve it through the use of this chart, contact your problems that are not equipment malfunctions. nearest Icom Dealer or Service Center. PROBLEM POSSIBLE CAUSE SOLUTION REF. -
Page 14: Options
OPTIONS • SP-35 external speaker Compact and easy-to-install. Input impedance: 4 ø Rated input: 5 W Maximum input: 7 W • HM-152 hand microphone • SM-26 desktop microphone • UR-FR5300/UR-FR6300 channel extension modules • UC-FR5300 trunking network controller Some options may not be available in some countries. Please ask your dealer for details. -
Page 15: Information
• Consult the dealer or an experienced radio/TV tech- nician for help. CAUTION: Changes or modifications to this repeater, not expressly approved by Icom Inc., could void your authority to operate this repeater under FCC regulations. - Page 16 A?????-1EX Printed in Japan 1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan © 2020 Icom Inc.