Prepare The Bobbin; To Remove; Wind The Bobbin - Kenmore 385.11607 Owner's Manual

SECTION 2. PREPARE THE MACHINE FOR SEWING i
Prepare the Bobbin
o To Remove the Bobbin Case from the Machine
f
Remove the extension table from
the machine by pulling it to the
left. Open the shuttle cover by
pulling down the embossed part on
the left side of the cover.
Raise needle to its highest position
by rotating hand wheel toward you.
To remove bobbin case from shut-
tle, pull open latch of bobbin case.
Pull bobbin case straight out of
shuttle.
• Wind the Bobbin
)
Release clutch by turning the
clutch knob inside the hand wheel
toward you to stop the needle from
moving while you wind the
bobbin.
NOTE:
The bobbin winder stopper can be adjusted for the amount of thread needed
on the bobbin (example 1/2 full or full etc.). To make the adjustment use
your large screw driver and loosen the screw one turn or less. This will allow
you to adjust the position of bobbin winder stopper. Do not take screw all
the wayout.
9