3M XT-1 Installation Manual page 38

Configuration
3M Headset Intercom System Model XT-1 Installation Manual
Page 38 of 54
Drive Thru Audio Duplex Mode
The system can function using half duplex or full duplex modes. Choosing
between the two modes is based upon the desired operation.
Note:
In half duplex installations, all latching order taking modes and hands free
mode are disabled.
Perform the following procedure to change the drive through audio mode:
1. Enter the base station configuration mode, see page 29.
2. Change the value for
Duplex Mode
•
In half-duplex systems, when the order taker is speaking, it is
impossible to hear any speech coming from the customer order
point.
•
In full-duplex systems, the order taker can speak and hear speech
coming from the customer order point at the same time.
Page Channel Heard by Order Taker
You can enable or disable the order taker from being able to hear any paging
while speaking to a customer over the customer order point. This may prevent
interference with the order taking process.
Perform the following procedure to enable or disable the order taker hearing
pages while talking:
1. Enter the base station configuration mode, see page 29.
Select 07 Global Settings
2.
3. To enable or disable the monitor playing the outbound talk, change the
value for
Number of Base Stations at this Site
When there are two base stations used together (tandem, dual, or side-by-side
drive thrus) they must be configured to work together.
Perform the following procedure to enable the two stations to work together:
1. On the base first station:
•
•
•
•
2. On the second base station:
•
•
•
•
07 Global Settings
Full Half
to or .
.
PAGE Channel Heard by Order Taker:
Enter the base station configuration mode, see page 29.
07 Global Settings
Change the value for
BaseStations at This Site
Press to implement the change.
Enter
On the first base station, stations, change the value for
Global Settings Lane Number of This Base
>
Station 1
to .
Enter the base station configuration mode, see page 29.
07 Global Settings
Change the value for
BaseStations at This Site
Press to implement the change.
Enter
On the second base station, stations, change the value for
Global Settings Lane Number of This Base
>
Station 2
to .
DriveThru Audio
>
NO YES
to or
Number of
>
2
to .
07
Number of
>
2
to .
07
Rev 1.0 © 3M 2007 November
.