Change Noise Reduction Level - 3M XT-1 Installation Manual

Configuration

Change Noise Reduction Level

3M Headset Intercom System Model XT-1 Installation Manual
Page 36 of 54
Remove Headsets
Perform the following steps to un-register a lost, destroyed, or otherwise
removed headset from the system, including a headset that is sent back to 3M
for repair. The headset would have to be registered again at a later date.
1. Enter the base station configuration mode, see page 29.
04 Registration
2. Select
3. Scroll to the number of the headset you want to un-register.
4. Press
Enter
Note:
If you do not know or have access to the number of the headset to be un-
registered, identify the headsets that you want to remain in service and un-
register any that remain on the list.
List All Headsets
To see a list of the registered headsets:
1. Enter the base station configuration mode, see page 29.
04 Registration
2. Select
Resetting Inactive Days
For any headset, you can manually reset its number of inactive days to zero (see
"Change Self Monitoring" on page 41 for information about the inactive days
timer.
To reset the inactive days:
1. Enter the base station configuration mode, see page 29.
2. Navigate to
3. Press
headset you want to reset.
<CLEAR>
4. Select
Checking Headset Software Revision
To check the software revision number for a headset:
1. Enter the base station configuration mode, see page 29.
2. Navigate to
3. Press
version appears next to the headset ID number.
There are several ways to improve the sound quality at the headset using the
following settings.
Inbound Microphone Noise Reduction Level
The inbound microphone noise reduction level setting reduces background noise
to make it easier to hear speech at the customer order point.
Perform the following steps to increase or decrease the noise reduction level.
1. Enter the base station configuration mode, see page 29.
2 Remove Headsets
>
.
3 List All Headsets
>
08 Headset Setup
>
or if necessary to scroll to the headset ID number for the
.
08 Headset Setup
>
or if necessary to scroll through the headsets. The software
.
.
Currently Editing Headset
Currently Editing Headset
Rev 1.0 © 3M 2007 November
.
.