Assembly Instructions - Flymo Mini Trim 2009 Original Instructions Manual

A
1
B
C
D1

Assembly Instructions

2
1
2
1
2
D2
Shaft Assembly (A)
1. Locate the lower shaft (A1) into the upper shaft
(A2).
2. Grasp firmly and hold steady the lower shaft.
Locate the upper shaft and snap together
firmly.
• The unit is correctly assembled when the gap
between the upper and lower shaft has been
closed.
Safety Guard Assembly (B) & (C)
1. Locate the safety guard (B1) over the cutting
head (B2). Ensure the nylon line is fed through
the hole in the safety guard as illustrated in fig
B.
2. Push into location and turn safety guard in the
direction illustrated in Fig C, until a click is
heard and the safety guard is securely locked
in position.
• ENSURE THE SAFETY GUARD IS SE-
CURELY IN PLACE BY ATTEMPTING TO
TWIST GUARD.
Cable Restraint (D1) & (D2)
1. Form loop in mains cable and push the loop
through the slot as illustrated in picture (D1).
2. To secure, position loop over the hook and pull
the cable back through the slot as illustrated in
picture (D2).