Flymo Electrolux Mini Trim Important Information Manual

Flymo mini trim operating instructions

Advertisement

For all customer enquiries or for replacement parts, contact:-
☎ ☎
01325 300303
www.flymo.com
eop.customer.services@electrolux.co.uk

Advertisement

Table of Contents
loading

Summary of Contents for Flymo Electrolux Mini Trim

  • Page 1 For all customer enquiries or for replacement parts, contact:- ☎ ☎ 01325 300303 www.flymo.com eop.customer.services@electrolux.co.uk...
  • Page 2: Carton Contents

    Lower Shaft Guard IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Electrolux Outdoor Products Customer Service Department direct Telephone : 01325 300303, Fax : 01325 318193 Please note: This manual covers various products.
  • Page 3: Cables

    10. Switch off, remove plug from mains and examine electric supply cable for damage or ageing before winding cable for storage. Do not repair a damaged cable, replace it with a new one. Use only Flymo replacement cable. 11. Always wind cable carefully, avoiding kinking.
  • Page 4: Starting And Stopping

    Disconnect the mains electricity supply before attempting any maintenance or adjustment. 1. Cut with cutting line at an angle using the tip (G). 2. Swing trimmer in and out of the cutting area taking small cuts (G).
  • Page 5: Manual Line Feed System

    (K). 4. Replace spool into spoolholder. Ensure spool is correctly fitted. Remember! Your Flymo trimmer is designed to use only nylon line with a maximum diameter of 1.5mm. Use only genuine Flymo nylon line. Fault Finding Hints...
  • Page 6: Automatic Line Feed System

    Eyelet 5. Refit the cap. To fit nylon line only: • Remember ! Your Flymo Trimmer is designed to use Cleat only nylon line with a maximum diameter of 1.5mm. Use only genuine Flymo nylon line.
  • Page 7: Maintenance

    LINE SNAPS CONTINUOUSLY IF NONE OF THE ABOVE OR IF FAULT PERSISTS After you have finished using your Flymo Mini-Trim follow the procedure below: 1. Disconnect from the mains electricity supply. 2. Never clean your trimmer with water, cleaning flu- ids, or solvents, just remove debris with a suitable tool, a soft brush or dry cloth.
  • Page 8: Ec Declaration Of Conformity

    I, the undersigned M. Bowden of Electrolux Outdoor Products, Aycliffe Industrial Park, NEWTON AYCLIFFE, Co. Durham. DL5 6UP. Certify that the product:- Category... Electric Lawn Trimmer Make... Electrolux Outdoor Products Conforms to the specifications of Directive 2000/14/EEC Type of Cutting Device...

Table of Contents