To Remove Spool; To Replace Nylon Line - Flymo Mini Trim 2009 Original Instructions Manual

H
Cleat
Latches
J
K
Line lock
hole
Manual Line Feed System cont'
Spool
Spoolholder
Slot
J1

To remove spool

1. Press and hold the two latches.
2. Pull spool out of spoolholder (H).
When refitting the spool
1. Keep all areas of the spool and spoolholder
clean. Failure to do so may prevent the spool
from being securely located in the spoolholder.
2. Make sure the line is placed through the slot in
the spoolholder (J).
3. Place spool into spoolholder and press down into
place.
4. Check that the spool is correctly fitted by trying
to remove the spool without depressing the
latches (J1).

To replace nylon line

Replacement line is available from most Husq-
varna UK Ltd. stockists. You can buy it either as
spool and line complete or as nylon line only.
To replace spool and line complete
1. Remove old spool.
2. Release line from cleat. Unwind approximately
100mm of line and feed through slot in spool-
holder (J).
3. Re-fit spool into spoolholder. Check that the
spool is locked in position.
To replace nylon line on spool
1. Take approximately 5 metres of line and insert
into one of the line lock holes in the spool (K).
2. Wind line onto spool in the direction of the ar-
rows on the top of the spool. Care should be
taken to ensure that the line is neatly coiled on
the spool (K).
3. Leave approximately 100mm of line unwound
and feed through slot in spoolholder (J).
4. Replace spool into spoolholder.
Ensure spool is correctly fitted.
Remember! Your trimmer is designed to use only
nylon line with a maximum diameter of 1.5mm. Use
only genuine Husqvarna UK Ltd. nylon line.
• Always return the product to its normal operat-
ing position before switching on.