Motion - EverFocus eZ.HD ECOR HD 16X1 User Manual

6.4.3

Motion

You can enable the Motion Event function and configured the related settings including
motion event notifications and motion areas in this menu.
Camera: Select a camera to be configured.
Enable: Check the box to enable the Motion Event settings for the selected camera.
Log: Check the box to record motion events to log data.
Pre-alarm Record: Check the box to start copying the recordings to the hard disk from 5 seconds before the
motion event occurs. Note that the pre-alarm recording rate will follow the Normal Speed configured in the
above section (see 6.2.1 Basic Setting).
Buzzer: Check the box to enable the buzzer when a motion event is triggered.
Email Notify: Check the box to send email notification when a motion event is detected. Email operation
requires valid email entered in the Email setup menu (see 6.7.2 Email).
Network Alarm: Check the box to send out a network alarm to a client PC when motion occurs. This feature
works with EverFocus' CMS software. You will need to configure the Alarm Server for the DVR to send network
alarms to the client PC (see 6.7.5 Alarm Server).
Auto Lock: Check the box and the events will be recorded in a write protected segment of the hard disk (will not
be overwritten). The DVR will lock a period of time when the alarm occurs. The length of the time depends on
DVR setting (see 6.5.2 Lock / Format).
FTP Upload: Check the box to enable uploading recordings to the FTP server function. To setup the FTP server,
please refer to 6.7.4 FTP.
80
ECOR HD 16X1 DVR