EverFocus eZ.HD ECOR HD 16X1 User Manual page 84

Auto Lock: Check the box and the events will be recorded in a write protected segment of the hard disk (will not
be overwritten). The DVR will lock a period of time when the alarm occurs. The length of the time depends on
DVR setting (see 6.5.2 Lock / Format).
FTP Upload: Check the box to enable uploading recordings to the FTP server function. To setup the FTP server,
please refer to 6.7.4 FTP.
FTP Upload File Type: Select MP4 file type to upload videos to FTP server; select JPEG file type to upload
snapshots to the FTP server.
Alarm Output: Select an alarm output number. When an alarm is triggered, the signal will be transmitted
through the selected alarm output relay.
Output Type: Select an output type when an alarm is triggered.
Timeout: Select this option and then set up the Timeout Duration in the field below, the alarm output will
last for the setup duration time (10 ~ 150 seconds).
Permanent: Alarm will remain active until the user presses the "Enter" key on the IR Remote Control or
resets the alarm remotely.
Transparent: Alarm output remains as long as the alarm input is active.
Trans + Timeout: Alarm output continues until event ends, then continues for the setup duration time (10 ~
150 seconds).
Timeout Duration: This function only appears when you select Timeout or Trans + Timeout options in the
Output Type drop-down list. Select a duration time for the motion event. The alarm output will last for the setup
duration time between 1 and 150 seconds.
Main Monitor: Select Full Screen to force the camera associated with the selected alarm number to display full
screen on the Main Monitor. The full screen camera view will last according to the Output Type selected in the
field above.
Call Monitor: Select Full Screen to force the camera associated with the selected alarm number to display full
screen on the Call Monitor. The full screen camera view will last according to the Output Type selected in the
field above.
Record: Select a camera to start recording when the associated alarm number is triggered.
Input Type: Select an input type when the selected alarm number is triggered. The options include N.O. and N.C.
Active Camera: This function is for associating an alarm trigger with a specific camera. For example, if you set up
an external motion detector near Camera 2, you can select Camera 2 in this field. The alarm will be associated
with this camera for full screen display, event logging and PTZ actions.
PTZ: If the Active Camera selected above is a PTZ camera, you can further set up the PTZ actions in this field.
The following time synchronization function must work with the radio-controller clock.
Time Sync Enable: Check to enable the time synchronization with the connected radio-controlled clock.
Time Sync Interval: Select a time sync interval time (by hour) for the DVR to synchronize the time with the
radio-controlled clock.
76
ECOR HD 16X1 DVR