Fuji Xerox DocuPrint C4350 User Manual page 313

Allocate Memory
The menu for changing the capacities of interface memory and form memory.
After changing the memory allocation capacity, all stored data in each memory may be erased due
●
to re-setting of the memory.
Memory exceeding total capacity cannot be allocated. If the value exceeds the capacity of the inter-
●
nal memory when the power is switched on, the memory allocation will be automatically adjusted
by the computer system. For details about memory allocation, refer to "1.5 About Allocation of
Memories" (P.20).
If setting the port to [Enable] leads to insufficient memory, the port status may be set to Disabled
●
automatically. In this case, either set the port to [Disable] when it is not used or change the memory
allocation capacity. However, the parallel port and the USB port are not automatically set to dis-
abled.
PS
Specify the memory capacity for the Post Script.
Set the memory capacity in the range of 8.00 to 96.00 MB, incremented by 0.25 MB. The default is
[24.00M]. The maximum value which can be set varies depending on the available memory.
HPGL Auto Layout
Specify the memory capacity for auto layout in the HP-GL/2.
Set the memory capacity in the range of 64 to 5,120 MB, incremented by 32 KB. The default is
[64K]. The maximum value that can be set varies depending on the available memory.
The Hard Disk Drive (optional) is used for memory if installed. The memory capacity cannot be
changed. On the LCD, [Hard Disk] is displayed.
Buffer Size
Set the memory capacity by each interface for reception buffer capacity, which is the area to store
transported data from the computer temporarily. Set the spool, setting area and the memory capacity
for LPD, SMB, and IPP.
You can change the receiving buffer capacity to status and destination. As the receiving buffer
capacity is increased, the print data processed in this printer will be released quickly by the applica-
tion program. The maximum setting value varies depending on the available memory.
When the port status is set to [Disable], no function is displayed.
●
Depending on transferred data, it may not be released quickly if the memory capacity is increased.
●
The optional values are as follows:
■Parallel Memory, NetWare Memory, IPP Memory, EtherTalk Memory, USB-1 (1.1) Memory,
USB-2 (2.0) Memory, Port9100 Memory
Set the memory capacity in the range of 64 to 1,024 KB, incremented by 32 KB. The default is [64K]
for Parallel and USB-1 (1.1)/USB-2 (2.0) and [256K] for Netware, IPP, and Port9100. Set [Ether-
Talk Memory] in the range of 1024 to 2048 KB. The default is [1024K].
■LPD Spool and SMB Spool
[Off] (default)
Print data is not spooled. While the printer is under printing process in LPD and SMB from a com-
puter, any data with the same interface from other computer cannot be received.
Set the LPD-only receive buffer capacity in the range of 1024 to 2048 KB, incremented by 32 KB.
The default is [1024K].
[Note 1] (P.289)
7.2 Description of Common Menu
7
285