Fuji Xerox DocuPrint C4350 User Manual page 296

Description of Common Menu
■PJL (Note 1) (P.289)
You can use the PJL command with this machine, which does not depend on any print language. The
PJL command controls the print job, and is necessary when you use the print driver. Set the status of
the PJL command sent from the computer to enabled or disabled. By using the PJL command, you
can select the print language for the next data, even if the printer is under another process in any print
language. Set [Enable] for normal use. The default is [Enable].
■Auto Eject Time (Note 1) (P.289)
Set the time to output remaining data in the printer, in case data transmission is interrupted. You can
select from 5 to 1275 seconds, in 5 second increments. The default is [30 Secs]. When the next data
is not received during this time, it is recognized as the end of job.
■Adobe Protocol
Set the communication protocol for PostScript.
[Normal] (default)
Set when the communication protocol is ASCII format.
[Binary]
Set when the communication protocol is Binary format. According to data, the processing speed of
printing in Binary format may be faster than that of [Normal].
[TBCP]
Set when both ASCII format and Binary format is installed in one communication protocol, and to
switch by a specified control code.
Set proper form according to data output by the print driver in the computer.
●
Use this menu in default, [Normal] for normal operation.
●
This settings can be used only when it is printed with PostScript.
●
USB-2 (2.1)
Set to use the USB 2.1 port.
The setting items and contents are the same as those of [USB-1 (1.1)].
The default is [Disable]. Set [Enable] when you use the USB port.
7
268