Table of Contents
Advertisement
W
T
F
AIT
IME
OR
The wait time for the Base Station to receive an acknowledge command
from the host is adjustable in twenty millisecond ticks, with a selectable
range from 000 to 255 (0 to 5.1 seconds). The factory default setting for
this feature is 200ms.
Wait time for host acknowledge is especially
critical when WACK mode is enabled, and should
be calculated using the formula below.
Wait Time
number of barcode characters x
To set the host acknowledge wait time:
1. Determine the desired wait time in twenty millisecond ticks
(for example: sixty).
2. Scan the SET label.
3. Scan the SET WAIT TIME FOR HOST ACKNOWLEDGE label.
4. Set the wait time by scanning the desired amount (note that
three digits are required). In the case of our example; 60
milliseconds would be selected by scanning 0-0-3 (20ms tick
x 3 = 60ms).
5. Scan the END label.
SET
-------------------------------------
S
W
T
ET
AIT
0 -----------------------------
1 -----------------------------
2 -----------------------------
R44-1027
H
A
OST
CKNOWLEDGE
WARNING
H
ACK ----
IME FOR
OST
number of bits per byte
baud rate + intercharacter
91
Advertisement
Table of Contents
