Chapter 12 Bandwidth Control; Configuring; Figure 41 Bandwidth Control; Table 24 Bandwidth Control - ZyXEL Communications GS-4012F User Manual

This chapter shows you how you can cap the maximum bandwidth allowed from specific
source(s) to specified destination(s) using the Bandwidth Control screen.

12.1 Configuring

Bandwidth control means defining a maximum allowable bandwidth for incoming and/or out-
going traffic flows on a port. Click Advanced Application and then Bandwidth Control in
the navigation panel to bring up the screen as shown next.

Figure 41 Bandwidth Control

The following table describes the related labels in this screen.

Table 24 Bandwidth Control

LABEL
Active
Port
Active
Ingress Rate
Egress Rate

Chapter 12 Bandwidth Control

Bandwidth Control
DESCRIPTION
Select this check box to enable bandwidth control on the switch.
This field displays the port number.
Make sure to select this check box to activate bandwidth control on a port.
Specify the maximum bandwidth allowed in megabits per second (Mbps) for the
incoming traffic flow on a port. Enter a number between 1 and 1000.
Specify the maximum bandwidth allowed in megabits per second (Mbps) for the out-
going traffic flow on a port. Enter a number between 1 and 1000.
C
H A P T E R
GS-4012F User's Guide
1 2
101