Ir450 Illuminator - ATN PS28 Operator's Manual

1. Remove the rubber cap from the connector. The rubber cap
can be placed onto the screw head, that attached the strap of
cap to the body of device (see Figure 2-7).
2. Attach the remote control to the connector and secure with the
captive nut.
3. Place the remote switch on the fore-end of rifle stock and with
Velcro tape.

2.1.7. IR450 ILLUMINATOR

IR450-B4 illuminator provides the capability for operator to use
the PS28 under extremely low light conditions and in total dark-
ness. The IR illuminator can be mounted on rail of the Platform
Ring, or on top rail of the B.A.M. system (see Figure 2-6), or of the
Scope Mounting System.
IR450 Installation:
1. Loosen the fixing nut of IR450.
2. Install the IR450 onto the Picatinny rail.
3. Tighten the fixing nut of IR450 tightly.
The ATN IR450 is powered with one CR123A lithium battery.
IR BRIGHTNESS ADJUSTMENT
IR WINDAGE
FIXING NUT
ADJUSTMENT
IR ELEVATION
ADJUSTMENT
IR FOCUSING
ALLEN KEY
FIGURE 2-8. IR450-B4
POWER LED INDICATOR
NUT
BATTERY HOUSING
WRENCH
BATTERY
HOUSING CAP
2-9