Table of Contents
Advertisement
VIVOTEK
NOTE:
1. WPS may not work if your AP is configured with a "hidden" SSID.
2. If the camera can not detect an AP after 2 minutes, the wireless setup will be cancelled.
3. If a camera is assigned with a fixed IP outside the AP's network segment, wireless setup will
fail.
4. A wired connection always has a higher priority. Unplug the LAN cable at an appropriate time
for the wireless setup to take effect.
5. The camera also supports manual configuration of wireless settings, enter the SSID (Service
Set Identifier) and security authentication password in a web console with the camera.
5-1. Enter the Configuration page -> Wireless.
5-2. Enter the SSID and password of your AP, select the Wireless mode as "Infrastructure."
5-3. Use the "ping <IP address> -t" command in a DOS prompt to observe wired connectivity.
Click the Save button. When wired connection is discontinued, unplug the LAN cable.
5-4. After several seconds, the camera will switch to wireless connection. Disconnect and
then connect the power cord to restart the camera, and you should be able to see live
video from the web console.
6. Select "Ad-Hoc" wireless mode if you prefer direct connection with a PC without the
intermediate AP or wireless router.
14 - User's Manual
Advertisement
Table of Contents
