Xerox DocuPrint C55 Service Manual page 147

ADJ 3.1.2B Black Density [NC60]
CHECKING THE BLACK DENSITY
1. Run a print of the Color Balance Test
Pattern (Menu Down until Color Adjust
then press Item Down).
2. Analyze the test page and choose the
number which represents
Density the customer desires.
mind that this is a 30% gray. Darker is not
always better.
ADJUSTING THE BLACK DENSITY
1. Perform the Black Density Check.
2. Press Item Up until Black Density is
displayed.
3. Press Value Up or Value Down to change
the numerical setting.
4. Press Enter.
5. Analyze the test page and determine if
additional adjustment is required.
6. Press On Line.
DocuPrint [NC60]
ADJ 3.1.2C Color Balance [NC60]
CHECKING THE COLOR BALANCE
1. Run a print of the Color Balance Test
Pattern (Menu Down until Color Adjust
then press Item Down).
2. Analyze the test page and choose the
the Black number which
Keep in Balance the customer desires
ADJUSTING THE COLOR BALANCE
1. Perform the Color Balance Check.
2. Press Item Up until Color Balance is
displayed.
3. Press Value Up or Value Down to change
the numerical setting.
4. Press Enter.
5. Analyze the test page and determine if
additional adjustment is required.
6. Press On Line.
represents the Color
2/99
4-59
REPAIRS/ADJUSTMENTS
ADJ 3.1.2