Xerox DocuPrint C55 Service Manual page 133

5. (Figure 3): Disconnect the three wire Exit
Sensor connector (CN308)
Connector PWB. Free the harness from the
wiring clips and cut any cable ties.
CN308
Figure 3. Disconnecting the Exit Sensor
DocuPrint C55/C55mp/[NC60]
6. (Figure 4): Remove the Right Pivot Arm:
from the
a. Remove the two E-Rings.
b. Carefully close the Transfer Assembly
and remove the spring.
c. Carefully support the bottom of the
Transfer Assembly and remove the Right
Pivot Arm.
E-Rings
T02A
Figure 4. Removing the Right Pivot Arm
7. (Figure 5): Disconnect the Left Pivot Arm:
Spring
Pivot
Arm
T03A
Figure 5. Disconnecting the Left Pivot Arm
2/99
4-45
a. Remove the E-Ring.
b. Carefully support the bottom of the
Transfer Assembly and Disconnect the
Left Pivot Arm from the Pin.
Pivot
Arm
E-Ring
REPAIRS/ADJUSTMENTS
REP 9.9
T03B