List Of Commands - Burnside TX2 User Manual

Example 1: "1234 cfg3=2"
Example 2: "1234 cfg3=2;cfg4=1"
If one or more space characters are used after the PIN, they will be ignored.
All commands that do not implicitly require a response are automatically replied to with a summary of
the terminal status. This automatic reply may be suppressed by placing a stop character after the pin
number. For example 1234. cfg3=2 will change the configuration without replying. An error in the
command will always result in a reply. The reply is either sent to the number that sent the command
or if a colon is used after the PIN, the reply will be sent to the number specified by PNUM11. For
example 1234: cfg3=2.
If the colon is used and PNUM11 is not programmed, no reply will be sent.

List of commands

Commands for all models:
CFG Read and write configuration settings.
PNUM Read and write phone number memories.
AUTO Sets automatic off-hook dial.
TPIN Read and write terminal PIN.
STAT Returns the status of the terminal.
STIME Time to send daily or periodic SMS status.
CLOCK Sets the clock to the time recorded in the SMS delivery.
CLRTEMP Clears the maximum and minimum temperature memory.
CLRCALL Ends any call in progress.
REPORT Report error event to specified destination number.
INIT Restarts the terminal.
VER Returns the firmware version number.
HVER Returns the hardware version number.
RESTORE Restores the default settings.
CODE Command to unlock optional features.
ON Turns the terminal on.
OFF Turns the terminal off.
Commands for TX2L and TX2LR:
MPREFIX Sets the prefix used to determine if the number is destined for the mobile network.
FORWARD Activate call forwarding without an announcement.
CANCEL Cancel call forwarding mode
ANNOUNCE User friendly way of turning on call forwarding with announcement.
ATTENDANT User friendly way of turning on call forwarding with auto-attendant announcement
PPREFIX Sets the prefix to optionally insert when dialling via the PSTN
IPREFIX Sets the IDD prefix that is used to convert "+" in phone numbers for PSTN dialling
Optional call logging commands for all models:
CLOG Returns the specified number of call log entries.
CLRLOG Clears the specified number of oldest call log entries.
LTIME Time to send regular SMS call log 24h format.
© 2014 Burnside Technology Ltd. Page 9 of 24
Rev 1.1