Table of Contents
Advertisement
If your cleaner is not working properly run through the
following checklist.
1.
Is there a working electricity supply to the cleaner?
Check with another electrical product.
2.
Is the dust bin full or choked with fine dust?
To empty the dust container, see instructions on P9.
3.
Is the hose blocked?
To clear a blockage, see instructions on P12.
4.
Is there a blockage in the cleaner base?
To clear a blockage, see the instruction on P12.
5.
Are the filters blocked?
To clean filters, see the instruction on P10.
6.
Are the brushes rotating correctly?
To check the brushes, see the instructions on p12.
7.
Has the cleaner overheated?
If so, it will take about 30 minutes to reset.
If there is any doubt call the Hoover Customer Helpline 08444 995 599 for
advice. They may be able to assist you over the telephone.
Globe manual.indd 14
User checklist
A thermal cut out switches off the cleaner to prevent
overheating if it is used when full or there is a blockage or
dirty filters. If this should happen switch off, unplug and
correct the fault.
It will take approximately 30 minutes for the cut out to
automatically reset.
DO NOT RUN OVER THE POWER SUPPLY CORD
AS THIS COULD DAMAGE THE SUPPLY CORD
INSULATION.
Rated Voltage:
CEE Wattage:
Dimensions:
- 14 -
WARNING
IMPORTANT
DATA
230 - 240 V ~ 50 Hz
900W
1110 x 308 x 409 mm
3/28/2012 3:59:42 PM
Advertisement
Table of Contents
