Table of Contents
Advertisement
GX15
2.3. Starting up
Connect GX15 to an operable serial port of the PC with the supplied data cable. Make sure that the battery is fully charged.
Start SPST from the desktop.
1. The Input password dialogue box appears. Enter the password, select "GX15" from Port list box (a connected port is automatically detected), and
click "OK". If you do not know SPC, click "Cancel" to exit.
2. To change the password, enter the current password in Figure 1, and then click "Change Password".
3. To check the usage status of tools, click "Show Repair Log" in Figure 1.
4. Click "Downloader for Emergency".
The above screen appears. Select a model to use and execute the Downloader. (Use this to initialise the flash, etc.)
CONFIDENTIAL
When using SPST for the first time, the driver installation
starts and the following dialogue box appears.
After the installation is complete, press "Retry".
Figure 1
Figure 2
Figure 3
2 – 2
Advertisement
Table of Contents
