Coffee Grinding Calibration; Setting The Water Capacity For Instant Product Solenoid Valves; Stirrer Supply - Saeco Atlante 500 Use And Maintenance Manual

English
• free the adjusting lever from the rack and put the internal
divider pulling peg into one of the 4 possible positions in
the basic coffee quantity area (7 gr - 8 gr - 9 gr - 10gr);
• move the adjusting lever into the rack and select the slot
corresponding to the dose required.
8.6

Coffee grinding calibration

Turn the ring until the required results are obtained.
After any calibration three selections are necessary before
the new setting becomes effective.
8.7 Setting the water capacity for
instant product solenoid valves
(Only version with instant product boiler)
To get a good quality of drinks, it is crucial to properly
adjust the brewing flow capacity. The machine is delivered
with a standard adjustment which ensures its correct
operation. For this reason, the brewing capacity is to be
adjusted only when solenoid valves are replaced or when
personalized settings are carried out.
40
To adjust the solenoid valve capacity turn the flow
regulating screw. Turn it clockwise to reduce water
capacity or anti-clockwise to increase it.
In the maintenance menu, a specific item (see sect.
"Description of messages in the maintenance menu") helps
carry out the adjustment by keeping the solenoid valve
open for a fixed time of 10". To adjust a solenoid valve for
instant products, proceed as follows:
1) Enter the WATER TEST menu (see sect. "Description
of messages in the maintenance menu");
2) Withdraw the dispensing spouts;
3) Place a container under the brewing spouts;
4) Select the required solenoid valve through the
UP/DOWN keys;
5) Press ENTER.
6) The chosen solenoid valve will remain open for 10". To
get the correct flow, 90 cc of water should come out in 10
secs.
If the quantity is not correct, turn the flow regulating
screw and repeat the procedure from point 4.
8.8

Stirrer supply

Use stirrers suitable for automatic vending, without
imperfections and conforming to the dimensions
indicated in "Technical Specifications".
Remove the metal counterweight from the stirrer guides.