Fitting The Payment Systems; Connection To Water Mains - Saeco Atlante 500 Use And Maintenance Manual

5.6

Fitting the payment systems

The vending machine is designed for the installation of
various payment systems, such as:
- parallel banknote reader 24V DC;
- parallel validator 24V DC
- executive systems (also PRICE HOLDING);
- MDB systems;
- BDV systems;
- cancelling machine 24V DC;
- parallel validator 12V DC (*);
- cashless reader;
(*) optional kit required.
The rotating coiner support is mounted from the serial
No. 9010ATL0001715.
The vending machine is not supplied with any payment
system, which must be installed by the person in
charge of its fitting.
After the chosen payment system has been installed,
the corresponding parameters can be set through the
programming menu (see section "Programming
menu").
To assemble the external antenna for the Contactless
payment systems it is recommended to drill the holes
in the area shown in the figure.
The Manufacturer declines any liability for any damage
to the vending machine, to property and/or injury to
persons, caused by the installation of the payment
system. The responsibility falls to the person who
carried out the installation.
5.7

Connection to water mains

It is recommended to use a descaling device for the
water network supplying the vending machine,
especially for water with a high calcium and
magnesium content (hard water).
Connect the vending machine to drinking water mains
with pressure between 0.15 MPA and 0.8 MPA (1.5
and 8 bar), see data on the label.
Before connecting the appliance to water network,
please read and follow the applicable regulations in
force in your country.
Remove the cap from the coupling placed on the vending
machine back panel. Connect the water network hose (supplied
with the appliance) to the vending machine 3/8" Gas coupling.
The water mains pipe should be certified according to the
standard IEC 61770.
The new hose-sets supplyed with the appliance are to be
used and that old hose-sets should not be reused.
English
33