Front Bezel And Display Panel - HP TouchSmart Elite 7320 Maintenance & Service Manual

Front Bezel and Display Panel

Description
21.5-inch, non-ZBD, CMI
21.5-inch, ZBD, Samsung
21.5-inch, non-ZBD, AUO
21.5-inch, LG
21.5-inch, ZBD, AUO
Front bezel
The front bezel is located on the front of the computer. You do not have to disassemble most internal
components to remove the front bezel. After lifting the main computer assembly from the bezel, the
display panel remains attached. This procedure demonstrates removing the front bezel and display
panel while keeping as much of the computer assembled as possible.
NOTE: You must calibrate the display panel after replacement. For calibration procedures, see
http://thesml.hp.com/results.htm?SID=5146296&MEID=DA800C0B-C65E-454F-
A8B4-17895E54764A.
To remove the front bezel:
1. Prepare the computer for disassembly (see
on page
2. Remove the rear cover (see
3. Remove the optical drive (see
4. Remove the speakers (see
5. Remove the webcam (see
6. Disconnect the flat ribbon cables from the touch controller board.
7. Disconnect the flat ribbon cable from the display that connects from the converter board.
8. Disconnect the logo cable from the bottom of the system board (1) and remove the cable from
the clips (2) in the computer.
Figure 7-52
40).
Rear Cover on page
Optical Drive on page
Speakers on page
Webcam Module on page
Disconnecting the logo cable
Preparing to Disassemble the Computer
41).
47).
58).
56).
Front Bezel and Display Panel
Spare part number
671571-001
671573-001
671574-001
671575-001
671577-001
671590-001
85