Table of Contents
Advertisement
CARING FOR YOUR HD PROJECTION DISPLAY
Your HD Projection Display will look better, have a longer
life and perform better if you care for it properly.
First check to see that the PRO895X is off. For
added safety, disconnect AC power to the
PRO895X.
Note: If you unplug your PRO895X, you will
have to reset the clock to the current time.
CABINET CARE
Non-Wood Cabinet or Cabinet Components. Moisten a soft
cloth with a mild soap solution. Wipe the surface with a
damp cloth. Then rinse the cloth in clean water and wipe
the surface again. Allow the PRO895X to air-dry before
turning it on.
LENS CLEANING
When the lenses of your HD Projection Display need clean-
ing, be sure to follow these directions so you do not dam-
age or scratch the optical coating on the lenses:
• Do NOT spray any type of fluid directly on
the lenses' surface.
• Use a soft cotton cloth (cotton diapers
laundered several times to remove sizing) or a
soft facial tissue.
• Do NOT use any type of aerosol cleaner.
• Do NOT use dry material, such as paper,
tissue or a dry cloth to clean the lenses.
P A G E 3 0
MAINTENANCE AND TROUBLESHOOTING
Moisten the soft cloth or tissue with warm water and gen-
tly wipe the surface of the lens.
Note: The lenses are easily damaged. Avoid accidental
contact with them.
EXTENDED ABSENCE
Before an extended absence (such as a vacation) you may
want to disconnect AC power to your PRO895X. This will
protect the HD Projection Display from possible damage
from lightning or power line surges. For added safety, you
may want to disconnect all video equipment currently con-
nected to the PRO895X.
Note: If you unplug your PRO895X, you will have to reset
the clock to the current time.
PICTURE INTERFERENCE
Your picture may be affected by interference caused by one
or a number of factors, including:
Speckled or Streaked Picture - Can be caused by nearby
automobile ignition, electrical appliances, etc. This is most
noticeable when there are loose connections to the unit.
Snow in Picture - Caused by insufficient signal - possibly
when the video cable is too long or broken, or has an
intermittent ground return.
206-3275-A
Advertisement
Table of Contents
