Table of Contents
Advertisement
Blank Setup (Continued)
Separate menus are available for adjusting the Top/Left and
Bottom/Right of the projected image as well as the Phase.
To adjust any option, see page 21 for basic menu opera-
tion.
(Blank Setup is normally adjusted by the installation
technician; usually no additional changes are needed.)
Notes:
• If you make changes to any option, you will be asked to save
them to the currently selected format. If the format is unknown,
store it as a new customer format.
Static Setup (Red, Blue, Green Convergence)
Occasionally the red, blue, and green images go out of
convergence. In the Static Setup Menu you will see a menu
similar to the one shown at the right. Ideally, the conver-
gence is correct when the bars in the center of the menu
are white.
Adjusting Convergence
Use the Up/Down/Left/Right arrows to converge Red and
Blue. You want to adjust each color so that the center area
of the bars is white. With the highlight on either the
Adjusting Red or Adjusting Blue rectangle, press MENU.
Move the color using the Up/Down/Left/Right arrows to
align the color to the center of the bars. The green does
not move; you are moving the Red and Blue over the green.
When the bars are white, the convergence re-alignment is
complete. Press QUIT to leave the menu.
Confirming Your Menu Changes
As indicated on the confirmation menu, press ENTER to
confirm your changes and save them.
206-3275-A
SETUP MENU
Press MENU for next adjustment.
Press
Use Arrows to Converge Red
Press MENU to Switch to Blue
to change setting.
P A G E 2 7
Advertisement
Table of Contents
