Baofeng UV-82 User Manual page 73

Menu Number
/ Short Name
Band Selection
In VFO/Frequency mode, sets [A] or [B] to the VHF or UHF band.
33
Settings: VHF[0] | UHF[1]
BAND
Note:
Dual Watch / Dual Reception Display Priority
When enabled, priority is returned to selected display once the signal in the other display
34
disappears.
TDR-AB
Settings: OFF[0] | A[1] | B[2]
Note: Requires menu 7 to be enabled
Squelch Tail Elimination - Transceiver
This function is used eliminate squelch tail noise between UV-5Rs that are communicating
directly (no repeater). A short duration 50Hz tone is transmitted when the PTT key is
35
released.
STE
Settings: OFF[0] | ON[1]
Note: Set to OFF before communicating through a repeater.
Note: Recommended setting is OFF
Squelch Tail Elimination - Repeater
This function is used eliminate squelch tail noise when communicating through a repeater.
36
Settings: OFF[0] | 1 - 10
RP-STE
Note: Requires use of a repeater utilizing this feature.
Note: Used with menu 37
Note: Recommended setting is OFF
Delay the Tail Tone of Repeater (X100 milliseconds)
37
Settings: OFF[0] | 1 - 10
RPT-RL
Note: Used with menu 36
Note: Recommended setting is OFF
Boot Display
Controls the behavior of the display when the transceiver is turned on.
38
Settings: FULL[0] | MSG[1]
PONMSG
FULL: Performs an LCD screen test at power-on
MSG: Displays a 2-line power-on message
Note: The power-on message must be edited with software
Roger Beep
Sends an end-of-transmission tone to indicate to other stations that the transmission has
39
ended.
ROGER
Settings: OFF[0] | ON[1]
Note: Recommended setting is OFF
Roger Beep – End of Reception
Emits an end-of-reception tone in the speaker when squelch closes on the selected
40
display.
A/B-BP
Settings: OFF[0] | A[1] | B[2]
Note: Useful when menu 7 is set to ON
Restore to Default Settings
Settings: VFO[0] | ALL[1]
VFO:
41
RESET
ALL:
Reference for UV-82 Menus
by Jim Unroe - KC9HI
(send comments, suggestions or corrections to UV-82@KC9HI.net)
Long Name / Description / Settings / Notes
When transitioning from VHF to UHF or from UHF to VHF, the
selected band's low frequency limit becomes the displayed frequency
(the original 'scratch' frequency is lost)
Resets all menus to firmware default and sets the [A] and [B] VFO
frequencies to firmware default.
Resets all menus to firmware default, sets the [A] VFO frequency to
the VHF band low limit and the [B] VFO frequency to the UHF band
low limit, erases all channels and programs channel 0 to 136.025
MHz and channel 127 to 470.625 MHz
11-January-2014
Default: VHF
Default: OFF
Default: ON
Default: 5
Default: OFF
Default: FULL
Default: OFF
Default: OFF
Default: ALL
Separate
MR/ VFO/
Channel Frequency
Global Mode Mode
RO ✓
✓
✓
✓
✓
✓
✓
✓
✓
Stored
VFO on a Per
A & B Channel
Settings Basis
✓ ✓