Programming A Channel With Any Offset; Summary Of Above Rx 146.700, Tx 146.100 Tone 123.0 (Optional) - Baofeng UV-82 User Manual

PROGRAMMING A CHANNEL WITH ANY OFFSET

Programming a Repeater Channel with any offset (Standard or Odd
Split)
This example is for: 146.700 MHz 600kHz minus offset into channel 99
CTCSS tone 123.0 (optional)
1. Set radio to VFO Mode (Frequency Mode)
a.) UV5R/GT3 - Press VFO/MR button
b.) UV82 - Turn radio OFF, then
Press/Hold MENU button during
PowerON.
2. Select Display A (this is a must)
a.) UV5R - Press [A/B] and select the Upper Display.
b.) UV82 - Press [EXIT A/B] and select the Upper Display.
3. Disable TDR (Dual Watch/Dual RX) which toggles between A and B.
Press [Menu] 7 [Menu]
Select OFF
Press [Menu] [Exit]
4. Delete Prior Data from the channel to be programmed.
Press [Menu] 2 8 [Menu]
Enter 9 9 (Memory Channel to clear)
Press [Menu] [Exit]
5. Store RX frequency
Enter 1 4 6 7 0 0
Press [Menu] 2 7 [Menu]
Enter 9 9 (Memory Channel)
Press [Menu] [Exit]
6. Set CTCSS or DCS codes for
Transmit. (if needed) ( example = CTCSS TX tone 123.0 Hz )
Press [Menu] 1 3 [Menu]
Enter 1 2 3 0 [Menu] [Exit]
7. Store TX frequency
Enter 1 4 6 1 0 0
Press [Menu] 2 7 [Menu]
Enter 9 9 (Memory Channel)
Press [Menu] [Exit]
8. The split is now programmed.
This procedure can be used to program standard offsets as well cross band.
If you know the repeater's RX and TX, you can program them separately without using
the repeater offset menus.

SUMMARY OF ABOVE RX 146.700, TX 146.100 TONE 123.0 (OPTIONAL)

1. Set radio to VFO Mode (Frequency Mode)
2. [EXIT A/B] must be set to Upper Display.
3. Turn TDR OFF [Menu] 7 [Menu] OFF
[Menu] [Exit]
4. Delete Prior Data
[Menu] 2 8 [Menu] Ch
PROGRAMMING MEMORIES BAOFENG UV 82
3